Donner Wireless DMX System [PB07]

What is it?

The Donner Wireless DMX512 Dongles allow for 3 PIN DMX512 devices to be connected over wireless 2.4GHz. They are rechargeable and support 500 Meters open air. 1 Dongle acts as the Master TX (has antenna) while the others act as RX

How if functions in our network?

In our system, we utilize Donner on Universe 5 for on stage. Master TX has a permanent setup in upper booth while RX's can be used throughout the theater. These dongles have been tested and work perfectly from upper booth to far backstage. 

Status Identification

TX

No Lights: Powered Off

Solid Red: Powered On & No DMX / Not Transmitting

Blinking Red means receiving & Transmitting DMX

RX

No Lights: Dead or Powered Off

Solid Red on both lights: Powered On & Not Receiving DMX from TX (Not Charging)

Solid Red & Strobing Green: Receiving DMX from TX (Not Charging)

Blinking Green & Solid Red: Powered On & Not Receiving DMX from TX (Charging)

Blinking Green & Strobing Green: Receiving DMX from TX (Charging)

Troubleshooting

Verify that both PB07 TX is plugged in and all PB07 RX have sufficient charge.

Verify that there is no frequency interference. Test them close together & far away

Press the small button on PB07 RX to turn it on

If PB07 TX is confirmed transmitting but PB07 RX isn't receiving, check the other RX modules. If all of PB07 RX have solid red, it is likely a transmitting problem. If you have some strobing green and others solid red, it's likely an RX issue.